You can use the Settings menu to configure the unit.
Depending on how you use your HMISCU, you can display the Settings menu using three different methods:
oUse a Switch,
oUse a Touch Animation
oTouch the top-left corner of the panel when powering up,
oTouch two corners of the panel successively while the application is running.
You can select which methods your application uses in the Vijeo Designer editor’s Target properties.
|
Step |
Action |
|---|---|
|
1 |
Set up any combination of the following methods for displaying the Settings menu. oAction: Create a switch and add the Configuration System Operation. See the Vijeo Designer online help for more information on creating a switch. oThere are actually 3 methods available to bring up the configuration: Top Left Corner In Target properties, set To Configuration to Top Left Corner. Top Left/2 Corner In Target properties, set To Configuration to Top Left/2 Corner. 2 Corner In Target properties, set To Configuration to 2 Corner (touch two corners successively. If you set To Configuration to None and do not create a switch to display the Settings menu, then there is no way to configure the unit at run time. |
|
2 |
Connect the power supply. |
|
3 |
Depending on what you set up in Step 1, you can display the Configuration menu using one of the following methods: oAction: Touch the switch set up with the Configuration system operation. oTop-Left Corner: Touch the top-left corner of the screen within ten seconds after the unit begins starting up. oTouch two corners successively: Touch successively the top left corner then the bottom right corner within half a second. The touch area is 50 dots by 50 dots. Vijeo Designer Runtime restarts and displays the Settings menu. |
|
4 |
The Settings menu contains 3 tabs: Offline, System, Diagnostics and To Run Mode. Click a tab to display its settings. |
