Message MS1453: Non continuous position: Y end of segment #{0} !- Y start of segment #{1}

Message MS1453: Non continuous position: Y end of segment #{0} != Y start of segment #{1}

Overview

Message ID	Message description	Message type
MS1453	Non continuous position: Y end of segment #{0} != Y start of segment #{1}	Error

Cause of the Message

The value you defined in the Motion diagram for the Y parameter of the end point of a cam or a load segment is greater than the Y parameter of the start point of the next cam or load segment.

Effect

Calculations cannot be performed.

Solution

Verify the Y parameter values for the subsequent cam or load segments. Make sure that the value for the Y parameter for the end point of a preceding segment is identical to the Y parameter of the start point of the following segment.