Overview
The use and application of the information contained herein require expertise in the design and programming of automated control systems. Only you, the user, machine builder or integrator, can be aware of all the conditions and factors present during installation and setup, operation, repair, and maintenance of the machine or process.
You must also consider any applicable standards and/or regulations with respect to grounding of all equipment. Verify compliance with any safety information, different electrical requirements, and normative standards that apply to your machine or process in the use of this equipment.
|
DANGER
|
|
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
-
Disconnect all power from all equipment including connected devices prior to removing any covers or doors, or installing or removing any accessories, hardware, cables, or wires except under the specific conditions specified in the appropriate hardware guide for this equipment.
-
Always use a properly rated voltage sensing device to confirm the power is off where and when indicated.
-
Replace and secure all covers, accessories, hardware, cables, and wires and confirm that a proper ground connection exists before applying power to this unit.
-
Use only the specified voltage when operating this equipment and any associated equipment.
Failure to follow these instructions will result in death or serious injury.
|
The segments and the carriers of the Lexium™ MC12 multi carrier may exceed 70 °C (158 °F) when subjected to heavy loads and/or high performance during operation.
|
WARNING
|
|
HOT SURFACES
-
Avoid unprotected contact with hot surfaces.
-
Do not allow flammable or heat-sensitive parts in the immediate vicinity of hot surfaces.
-
Verify that the heat dissipation is sufficient by performing a test run under maximum load conditions.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
|