Disassembling a TM2 / TM3 Module from the Adaptor Module
This section describes the procedure to disassemble a TM2 / TM3 expansion module from the TM2DOCKN adaptor module.
|
|
|
HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH |
|
oDisconnect all power from all equipment including connected devices prior to removing any covers or doors, or installing or removing any accessories, hardware, cables, or wires except under the specific conditions specified in the appropriate hardware guide for this equipment. oAlways use a properly rated voltage sensing device to confirm the power is off where and when indicated. oReplace and secure all covers, accessories, hardware, cables, and wires and confirm that a proper ground connection exists before applying power to the unit. oUse only the specified voltage when operating this equipment and any associated products. |
|
Failure to follow these instructions will result in death or serious injury. |
Disassembling an Expansion Module from the Adaptor Module
|
Step |
Action |
|---|---|
|
1 |
Remove all power from the control system. |
|
2 |
Unplug the ribbon cable of the adaptor module from the controller or from the TM2...N expansion module to which it is attached. |
|
3 |
Dismount the assembled adaptor module and TM2 / TM3 expansion modules from the mounting panel or rail. |
|
4 |
Push up the locking device from the bottom of the TM2 / TM3 module to disengage it from the adaptor module. |
|
5 |
Pull apart the adaptor and the expansion module. |
