|
Type |
AS |
|
Devices supporting the parameter |
Lexium LXM52 Drive, Lexium LXM52 Linear Drive, Lexium LXM62 Drive, Lexium LXM62 Linear Drive, Lexium ILM62 Drive Module |
|
Traceable |
No |
Displays the power stage temperature in °C. This temperature is measured with a temperature sensor on the power stage of the device. The diagnostic messages 8126 Power stage temperature high and 8101 Power Stage overtemperature are triggered by this temperature. The maximum power stage temperature is defined in the device type plate. The warning limit is also defined in the device type plate from device type plate version 25 or higher. Otherwise it is defined 10 degrees Celsius below the error limit.
NOTE: The parameter value is transferred from the slave to the master via the parameter channel of the Sercos by every access. Typically, this takes about 10 ms. By a high capacity of the parameter channel, times up to 1 s can occur. If the Sercos bus is in phase 0 or 1, then a standard value is indicated here. If the Sercos bus is in phase 3 or 4, then the parameter value is transferred and indicated. In the Sercos phase 2, the parameter can be read through the application.
