8780 - 8969

What Is in This Chapter?

• 8780 Encoder output frequence > 1MHz

• 8781 Master Encoder no connection

• 8782 Master Encoder signal out of range

• 8785 Hardware defect detected

• 8786 Asynchronous to Sercos bus

• 8787 Configuration error

• 8788 Wiring error detected

• 8789 PacNet comm. disturbance detected

• 8790 Module error detected

• 8791 TM5/TM7 module error detected

• 8792 SoSafe configuration mismatch

• 8800 Insufficient working memory

• 8826 PIC update not possible

• 8827 Controller power-off/hardware monitor

• 8828 Library

• 8829 Velocity too high for ZeroTrack

• 8830 PacNet BusAddr duplicated

• 8902 Software error (page fault)

• 8903 Software error detected (class 3)

• 8904 Software error detected (class 4)

• 8905 FC_UserRefGeneratorStart not possible

• 8906 ControlMode invalid

• 8907 Encoder interface invalid

• 8908 Unintended motor operation detected

• 8909 Motor type plate parameter invalid

• 8910 Reference value invalid

• 8911 Name too long

• 8915 Selected EncoderMode not supported

• 8916 Wrong ControlMode selected

• 8917 Machine encoder interface is invalid

• 8918 Machine encoder communication is not possible

• 8919 Machine encoder type plate parameter is invalid

• 8957 Sercos bus topology changed

• 8958 Encoder communication not possible

• 8959 Mains contactor error detected

• 8960 Invalid mains voltage mode setting

• 8961 Phase missing message

• 8963 NRT IPAddr not in IPAddressRangeStatic

• 8964 NRT IPAddressRangeDynamic used up

• 8965 NRT IP parameter read not possible

• 8966 NRT IP parameter write not possible

• 8967 NRT IP parameter device different

• 8968 NRT network overlapping detected

• 8969 Motor cable not connected