Overview
The use and application of the information contained herein require expertise in the design and programming of automated control systems. Only you, the user, machine builder or integrator, can be aware of all the conditions and factors present during installation and setup, operation, repair, and maintenance of the machine or process.
You must also consider any applicable standards and/or regulations with respect to grounding of all equipment. Verify compliance with any safety information, different electrical requirements, and normative standards that apply to your machine or process in the use of this equipment.
|
DANGER
|
|
ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
-
Disconnect all power from all equipment including connected devices prior to removing any covers or doors, or installing or removing any accessories, hardware, cables, or wires except under the specific conditions specified in the appropriate hardware guide for this equipment.
-
Always use a properly rated voltage sensing device to confirm the power is off where and when indicated.
-
Operate electrical components only with a connected protective ground (earth) cable.
-
Verify the secure connection of the protective ground (earth) cable to all electrical devices to ensure that connection complies with the connection diagram.
-
Do not touch the electrical connection points of the components when the module is energized.
-
Provide protection against indirect contact.
-
Insulate any unused conductors on both ends of the motor cable.
Failure to follow these instructions will result in death or serious injury.
|
Poor maintenance can lead to premature wear, or even present potential safety hazards for production or maintenance operators.
|
WARNING
|
|
UNINTENDED EQUIPMENT OPERATION
Develop and follow a maintenance plan and associated protocols adapted to the requirements of your application and equipment.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
|
Servicing
In case of issues which cannot be resolved, contact your local Schneider Electric service representative with the following information:
-
Type plate information (type, identification number, serial number, DOM)
-
Detailed description of the issue
-
Previous and associated circumstances