Message MS1451: Gap between segments: X end of segment #{0} < X start of segment #{1}

Overview

Message ID	Message description	Message type
MS1451	Gap between segments: X end of segment #{0} < X start of segment #{1}	Error

Cause of the Message

The value you defined in the Motion diagram for the X parameter of the end point of a cam or a load segment is less than the X parameter of the start point of the next cam or load segment.

Effect

Calculations cannot be performed.

Solution

Verify the X parameter values for the subsequent cam or load segments. Make sure that the X parameter of the end point of a preceding segment is identical to the X parameter of the start point of the following segment.