8400 - 8779

What Is in This Chapter?

• 8400 Program diagnostic message class 0

• 8401 Program diagnostic message class 1

• 8402 Program diagnostic message class 2

• 8403 Program diagnostic message class 3

• 8404 Program diagnostic message class 4

• 8501 Sercos slave not found

• 8503 SERCOS service channel error detected

• 8504 Sercos read cycle overflow

• 8505 Sercos Master comm.disturbance detected

• 8506 Sercos Master comm. not possible

• 8507 Sercos write cycle overflow

• 8508 Sercos run-up not possible

• 8509 Sercos slave SW not supported

• 8510 Sercos Interrupt lost

• 8511 CPU time overflow

• 8512 Sercos wrong device type

• 8517 Sercos addressing not unique

• 8518 Sercos too many real slaves

• 8519 Sercos connection configuration

• 8520 Sercos C2C misconfiguration detected

• 8521 Sercos C2C configuration

• 8522 C2C encoder error detected

• 8523 C2C Slave state

• 8524 Slave comm. disturbance detected

• 8525 C2C Slave comm. error detected

• 8526 C2C Slave critical error

• 8527 C2C Slave error detected

• 8529 Sercos Slave C1D error detected

• 8530 Sercos Slave C2D warning detected

• 8532 Sercos Logical Slave not unique

• 8550 Cybersecurity device lock status

• 8551 Uncontrolled carrier received

• 8552 Sercos cycle time too short

• 8553 Segment power consumption near limit

• 8560 Power stage hardware error detected

• 8561 Segment to segment connection error detected

• 8562 Carrier negotiation communication error detected

• 8563 Encoder error detected

• 8564 Carrier is lost

• 8565 Track is not the first Sercos device on the LMC

• 8566 LMC connected to the incorrect port of the track

• 8567 Segment coil overload

• 8568 Segment coil load is high

• 8569 Coil break detected

• 8570 Carrier not found

• 8571 Logical Carrier not unique

• 8572 Physical Carrier not unique

• 8573 Wrong Segment Geometry

• 8574 Unconfigured physical carrier found

• 8600 Master Encoder comm. not possible

• 8601 Master Encoder signal out of range

• 8710 Communication error

• 8720 No module found

• 8722 No cyclic telegram

• 8723 No Profibus config data

• 8725 Firmware of the module was replaced

• 8726 Firmware of the module is incorrect

• 8730 Bad master parameter data

• 8731 Automatic bus deactivation

• 8732 Slave not responding

• 8733 Fatal bus error

• 8740 Device cannot be disabled