Setting functions that can be used during operation, without restarting the setting wizard, are:
oModifying the general settings
oEditing devices
oAdding single IP devices manually
During operation, you can access the General settings menu by pressing 
.
Limitations
When the following devices are used together, you cannot write or edit the device name:
oMasterPact with BCM module, firmware version lower than 3.2.5.
oComPact NS with BCM module, firmware version lower than 3.2.5.
oPowerPact P- and R-frame with BCM module, firmware version lower than 3.2.5.
An example network architecture is provided in this guide.
Prerequisites
Before editing devices, you must verify that the following prerequisites are met:
oCircuit breaker must be in the remote control mode.
oDevice logging in the IFE or EIFE webpage must be disabled.
oOnly the following characters are allowed:
oUpper case letters from A to Z
oLower case letters from a to z
oDigits from 0 to 9
oHyphen -
oBefore editing the name and label of the circuit breaker:
oThe EIFE intrusive command mode must be unlocked
oThe locking pad of the IFE, or IFM interface must point to the open padlock, as shown in the following graphic
When the communication network is configured, access the Editing devices menu by pressing 
.
Use the Editing devices menu to:
oProvide a label for each device:
The label is defined in the ID field and is only displayed in the FDM128 display. The ID field contains up to 4 characters.
oRename a device:
The name is defined in Name field and is the actual name of the device. You may need to use the device password to rename the device. The Name field contains up to 12 characters.
NOTE: Press OK to validate the settings and go back to the operation mode.
During operation, you can access the Communication settings menu by pressing 
.
Use this menu to:
oView the present communication settings configuration.
oRestart the setting wizard, beginning at the point following the general settings, where you can modify the FDM128 display settings.
oIf the number of devices is less than eight, manually add an IFE interface, an EIFE interface, an Acti9 Smartlink SI B, or an Acti9 Smartlink SI D.
During operation, you can access the Access Code settings menu by pressing 
. Use this menu to view and edit user login and access code settings.
